Hexagon Basket Sewing Pattern
Difficulty level: Basic
Time required: Approx 2 hours.
1. Silk, 15″ x 15″
2. Satin lining, 15″ x 15″
3. Thick cardboard (about 1mm thickness), 15″ x 15″
4. Batting (low loft), 15″ x 15″
5. Cords (72″) or ribbons (72″) or china knots & loops (6 pairs)
6. Rick racks (optional)
1. Sewing machine
2. Heavy sewing needle that can handle thick material
3. Scissors for fabric and cardboard
4. Drawing Compass
5. Pencil (sharpened)
7. Right angle ruler
8. 3M Spray Adhesive or equivalent
9. Fabric glue or hot glue
10. Matching sewing thread
Download the instruction on how to draw the hexagon cardboard. It is basically derived from 2 hexagons (4″ & 6″) with same center point. For detail on how to draw basic hexagon with step-by-step photo, click here.
If you have a wide printer, you can simply double the size the of the pdf document and print it out.
Cut cardboard by following the outer pink line of the drawing. Use cardboard as pattern reference, cut batting, cut silk and satin (with 3/4″ to 1″ seam allowance).
3. Sating lining
Mark the cardboard outline on the wrong side of the satin lining & silk.
Trim off the diamond shapes (between the flaps) from the cardboard. To prevent the sharp edges from spoiling the dedicated satin, smooth out all corners by trimming them round.
Spray adhesive on the batting and cardboard (follow the instruction on the can). It is sticky and tacky, so be careful when handling.
Position the batting (with adhesive side down) on the wrong side of the silk. Due to the slippery of the silk material, align the corners and outline before press the batting to the silk by hand.
Repeat the same to cardboard and satin.
Glide you hand across the right side the satin and silk to smooth out the adhesive and get rid of any bubbles captured within.
Place some fabric glue near the edges of the cardboard flaps. Fold the seam allowance and stick to the cardboard and batting for both satin and silk.
Secure the adhesion with pins on silk since it is a little difficult to set in place.
Spray adhesive to the wrong side of the satin set. With adhesive side down and wrong side facing each other, position the satin on top of the silk set.
Adjust the corners so that both layers are aligned. Pin to secure.
Cut cord or ribbon to 6″ length, 12 pieces. Insert the cord between the silk and satin with 1″ depth at the vertical edge of the cardboard. Repeat all 12 cords.
Sew near edges around the basket to stitch up both layers.
Top stitch around the cardboard. Note that the vertical lines are next to the cardboard and not on the cardboard.
Top stitch the smaller hexagon inside the basket, slowly to prevent needle breakage.
After finish sewing through the cardboard, the sewing machine’s needle is more or less damaged. Dispose it correctly.
Glue rick rack to the edges with fabric glue as optional decoration. Set aside to let it dry.
Bend the flaps and fold over to form the sides of the basket.
Tie the cords or ribbons to entrench it.
The Hexagon Basket is ready to be used.